maximum temperature rise

英 [ˈmæksɪməm ˈtemprətʃə(r) raɪz] 美 [ˈmæksɪməm ˈtemprətʃər raɪz]

网络  最高温升

化学



双语例句

  1. Frequency-sensitive equipment shall be tested at rated frequency, and equipment marked with more than one frequency shall be tested at the frequency that will produce the maximum temperature rise.
    对频率敏感的设备应在其额定频率下对其进行测定。设备上还要标明不只一个能使设备温度最大限度增高的频率值。
  2. This paper introduced an new instrument which was used in thermal hazard analysis-accelerating rate calorimeter ( ARC). Its design principle and inner structure, run modes and the data types including temperature, pressure and the time to maximum temperature rise rate were presented.
    本文介绍了一种新型热危险性分析仪器&绝热加速量热仪的设计原理和内部结构,运行模式以及所能获得的温度、压力和最大温升速率时间等数据类型。
  3. Besides, the film thickness is greatly dependent on the value of r w, but the maximum pressure, the maximum temperature and friction coefficient are related with the value of r w to limited extent. Research on the lean blow-out stabilities of the high temperature rise combustor
    而rw对油膜最大压力、最高温升及摩擦系数的影响较小高温升燃烧室贫油熄火稳定性研究
  4. Compared to the calculation results with the assumption of radial heat flow in laser rod, the maximum temperature rise is reduced by 30%.
    与棒内热流线径向假设计算结果对比,激光棒的最高温升值减小了30%。
  5. The temperature measurement after improvement showed that the maximum temperature rise in the fixture is less than 80 K.
    改造后的温度测试表明,夹件最热点温升不超过80K。
  6. The maximum permissible temperature and temperature rise of various components, in particular the contacts, the connection terminals and the conductions connected to them;
    不同组件,特别是触头,接线端子和连接它们的导体的最大容许温度和温升;
  7. Distribution of stress, strain and milling temperature showed that stress is localized in the primary shear zone, while the maximum strain and temperature rise occurs along the tool-chip interface.
    对应力、应变和切削温度分布的分析表明,应力主要集中在第一剪切区,而应变和温度的最大值在刀-屑接触面上。
  8. Increasing gas concentration or adding obstacles in tube, at the range of experimental condition, flame propagation speed will increase, at the same time the maximum temperature of dynamic flame will rise relatively. 4.
    在实验范围内增加瓦斯浓度或管道内置障后,随着火焰传播速度的增加,管道内动态火焰的最高温度值相应上升。
  9. In order to effectively analyze the thermal properties of motorized spindle, we select grinding spindle which maximum speed is 60000r/ min, analyse its thermal properties by using finite element method and carry out experimental study of temperature rise.
    为有效分析电主轴的热态性能,本文选用最高转速为60000r/min的磨削类高速电主轴,运用有限元法对其热态性能进行了深入分析,并开展了温升实验研究。
  10. At the end of heating the maximum temperature rise was significantly mitigated with increasing loading of nanoparticles.
    在加热周期结束时,加热面上的最大温升随着纳米颗粒的引入得到了极大的缓和。
  11. The key consideration and the pouring temperature of the concrete under low temperature construction, curing temperature, heat storage and holding time parameters on the maximum temperature rise inside the concrete, as well as the size of the surface tensile stress, and draw some useful conclusions.
    重点考虑和阐述了混凝土在冬季施工下的浇注温度、养护温度、蓄热保温时间等参数对混凝土内部最高温升以及表面拉应力大小的影响,得出了一些有益的结论。